HP EliteDesk 800 G4 Base Model Small Form Factor PC Manual de usuario descargar pdf (Pagina 43)

14. Replace the computer access panel.

15. If the computer was on a stand, replace the stand.

16. Reconnect the power cord and any external devices, and then turn on the computer.

17. Lock any security devices that were disengaged when the access panel was removed.

Removing and installing an M.2 SSD storage card

NOTE: There are two M.2 SSD sockets on the system board. The computer supports 2230 and 2280 M.2 SSD

cards.

1. Remove/disengage any security devices that prohibit opening the computer.

2. Remove all removable media, such as compact discs or USB ash drives, from the computer.

3. Turn o the computer properly through the operating system, and turn o any external devices.

4. Disconnect the power cord from the AC outlet and disconnect any external devices.

IMPORTANT: Regardless of the power-on state, voltage is always present on the system board as long

as the system is plugged into an active AC outlet. To prevent damage to internal components, you must

disconnect the power cord from the power source before opening the computer.

5. If the computer is on a stand, remove the computer from the stand.

6. Remove the computer access panel.

7. Remove the front bezel.

8. Rotate the drive cage to its upright position.

Removing and installing drives 37

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 59 60

Sin comentarios

HP EliteDesk 800 G4 Base Model Small Form Factor PC Manual de usuario Pagina 43