HP FB910 Guía de usuario descargar pdf (Pagina 8)

9. Place an absorbent pad on top of the Saran Wrap. The pad and the wrap are to prevent any

seeping liquids from getting on the belt or into the vacuum table.

10. Place a foam pad onto of the Saran Wrap and absorbent pad. This foam pad is the primary

cushioning for the carriage to rest upon.

11. Place another piece of Saran Wrap on top of the foam pad.

12. Place several lint-free cloths on the Saran Wrap/pad.

13. Apply a generous quantity of HP Printhead Flush to the lint-free cloths.

14. Carefully lift the carriage up and off of the rail and place it gently onto the lint-free cloths/Saran

Wrap/foam pad construct on the belt, repositioning it as necessary to accommodate the

carriage.

15. Place another piece of foam behind the carriage so that it is between the carriage and the belt.

This foam pad is the primary cushioning to prevent the rail and the carriage wheels from

damage. Use as much foam as necessary to fully separate the wheels and the rail.

16. Use shrink/stretch wrap, banding, or other appropriate restraining materials to immobilize the

carriage and padding so that it cannot shift left to right nor bounce up and down. If metal or

plastic banding is used, use foam sheets and/or cardboard shims to prevent the banding from

digging in to printer components such as the belt or rail.

The carriage is now prepared for transport. Continue with preparation of the printer chassis.

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

HP FB910 Guía de usuario Pagina 8