HP ProDesk 400 G2 Microtower PC Manual de usuario descargar pdf (Pagina 25)

Removing and Installing drives

When installing drives, follow these guidelines:

●

The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA

connector on the system board labeled SATA0.

●

Connect a secondary hard drive to the light blue SATA connector on the system board labeled

SATA1.

●

Connect an optical drive to one of the white SATA connectors on the system board labeled

SATA4 or SATA5.

●

HP has provided four extra 6-32 hard drive mounting screws installed on the front of the chassis

behind the bezel (1). The mounting screws are required for 3.5-inch and 2.5-inch hard drives

installed in the hard drive bays. If you are replacing a drive, remove the mounting screws from

the old drive and install them in the new drive.

CAUTION: To prevent loss of work and damage to the computer or drive:

If you are inserting or removing a drive, shut down the operating system properly, turn off the

computer, and unplug the power cord. Do not remove a drive while the computer is on or in standby

mode.

Before handling a drive, ensure that you are discharged of static electricity. While handling a drive,

avoid touching the connector. For more information about preventing electrostatic damage, refer to

Electrostatic discharge on page 38.

Handle a drive carefully; do not drop it.

Do not use excessive force when inserting a drive.

Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields

such as monitors or speakers.

If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and

label the package “Fragile: Handle With Care.”

Removing and Installing drives 19

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 46 47

Sin comentarios

HP ProDesk 400 G2 Microtower PC Manual de usuario Pagina 25