
Drive cage
Follow these steps to remove the drive cage:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 28).
2. Remove the access panel (see Access panel on page 29).
3. Disconnect the power cable (1) from the 2.5-inch hard drive.
4. Disconnect the data cable (2) from the 2.5-inch hard drive.
5. Disconnect the power cable (1) from the 3.5-inch hard drive.
6. Disconnect the data cable (2) from the 3.5-inch hard drive.
7. Press down on the drive cage release tab (1).
8. Lift the right side of the drive cage (2) until it rests at an angle.
32 Chapter 4 Removal and replacement procedures
Comentarios a estos manuales