HP ProDesk 600 G4 Base Model Small Form Factor PC Manual de usuario descargar pdf (Pagina 31)

Installing a 9.5 mm slim optical drive

1. Remove/disengage any security devices that prohibit opening the computer.

2. Remove all removable media, such as compact discs or USB ash drives, from the computer.

3. Turn o the computer properly through the operating system, and turn o any external devices.

4. Disconnect the power cord from the AC outlet and disconnect any external devices.

IMPORTANT: Regardless of the power-on state, voltage is always present on the system board as long

as the system is plugged into an active AC outlet. To prevent damage to internal components, you must

disconnect the power cord from the power source before opening the computer.

5. If the computer is on a stand, remove the computer from the stand.

6. Remove the computer access panel.

7. If you are installing a slim optical drive in a bay covered by a bezel blank, remove the front bezel and

then remove the bezel blank. See Removing a slim optical drive bezel blank on page 8 for more

information.

8. Align the small pin on the release latch with the small hole on the side of the drive and press the latch

rmly onto the drive.

Removing and installing drives 25

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 55 56

Sin comentarios

HP ProDesk 600 G4 Base Model Small Form Factor PC Manual de usuario Pagina 31