Hp Insight Management-Software Manual de usuario descargar pdf (Pagina 44)

Figure 3-12 VC Domain Group with VC Domains that have different numbers of enclosures

A multienclosure domain can only be configured as follows:

• The enclosure must be a c7000 enclosure.

• Primary and secondary Virtual Connect Ethernet modules must be either the HP 1/10Gb-F

Virtual Connect Ethernet Module or the HP Virtual Connect Flex-10 10Gb Ethernet Module

running VC firmware 2.1x or later.

• FC modules in every enclosure must match the model and disposition.

To manage multienclosure domains in VCEM you would proceed in the same way as with single

enclosure domains:

1. License all enclosures. For more information, see “VCEM cabinet licensing”.

2. Provide credentials as needed.

3. Configure the VC Domain Group. For more information, see “Creating a VC Domain Group”

(page 53).

VCEM supports multienclosure domains with a different number of enclosures in the same VC

Domain Group. For example, you can configure a group with two VC Domains if one VC Domain

has two enclosures, and the other VC Domain has four enclosures. You can perform this

configuration provided that the base configurations of both VC domains are equal.

IMPORTANT: When configuring the VC Domain, you must add the remote enclosures in the

correct order. Virtual Connect Manager tracks the order of the enclosures that are added. If you

add the remote enclosures and one VC Domain follows a different order than the others, VCEM

fails to manage that VC Domain.

The VC module disposition between two VC Domains must match for them to be included in the

same VC Domain Group.

For more information, see HP Virtual Connect Manager documentation.

44 Managing VC Domains

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 128 129

Sin comentarios

Hp Insight Management-Software Manual de usuario Pagina 44