HP ProCurve 5400zl Manual de usuario descargar pdf (Pagina 87)

B-1

Switch Ports and Network

Cables

Switch Ports and Network Cables

This appendix includes switch connector information and network cable

information for cables that should be used with the Series 5400zl Switches,

including minimum pin-out information and specifications for twisted-pair

cables.

Note Incorrectly wired cabling is the most common cause of problems for LAN

communications. It is recommended that you work with a qualified LAN cable

installer for assistance with your cabling requirements.

Switch Ports

Twisted Pair

■ The RJ-45 ports on the modules accept 100-ohm differential unshielded

and shielded twisted-pair cable with RJ-45 connectors as described on the

next page.

Fiber-Optic

■ The LC-type connector port on the Gigabit-SX mini-GBIC transmits at

850 nm wavelength, and accepts the low metal content, multimode fiber-

optic cables for Gigabit-SX described on page B-3.

■ The LC-type connector port on the Gigabit-LX mini-GBIC transmits at

1310 nm wavelength, and accepts the low metal content, single-mode or

multimode fiber-optic cables for Gigabit-LX described on page B-3.

■ The LC-type connector port on the Gigabit-LH mini-GBIC transmits at

1550 nm wavelength, and accepts the low metal content, single-mode or

multimode fiber-optic cables for Gigabit-LH described on page B-3.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 117 118

Sin comentarios

HP ProCurve 5400zl Manual de usuario Pagina 87