Hp ProLiant DL360 G7 Server Manual de usuario descargar pdf (Pagina 20)

Operations 20

Remove the access panel

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the

internal system components to cool before touching them.

CAUTION: Do not operate the server for long periods with the access panel open or removed.

Operating the server in this manner results in improper airflow and improper cooling that can

lead to thermal damage.

To remove the component:

1. Power down the server (on page 18).

2. Extend the server from the rack (on page 18).

3. Open the locking latch, slide the access panel to the rear of the chassis, and remove the access panel.

If the locking latch is locked use a T-15 Torx screwdriver to unlock the latch.

Install the access panel

1. Place the access panel on top of the server with the hood latch open. Allow the panel to extend past the

rear of the server approximately 1.25 cm (0.5 in).

2. Push down on the hood latch. The access panel slides to a closed position.

3. Use the T-15 Torx screwdriver provided with the server to tighten the security screw on the hood latch.

Remove the BBWC battery pack or the FBWC

capacitor pack

1. Power down the server (on page 18).

2. Extend the server from the rack (on page 18).

3. Remove the access panel (on page 20).

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 129 130

Sin comentarios

Hp ProLiant DL360 G7 Server Manual de usuario Pagina 20