Hp ProLiant SL230s Gen8 Server Manual de usuario descargar pdf (Pagina 42)

Hardware options installation 42

Remove the FBWC capacitor pack holder to enable cable routing.

9. Connect the power cable to the personality board.

10. Route the power cable along the side of server.

11. Connect the power cable to the drive backplane. If only one drive cage is being installed, route the

unused cable to the side of the tray:

NOTE: In the following figures, the drive cage location for single SFF hot-plug drive cage

installation is depicted in the right bay, but the single SFF hot-plug drive cage can be installed in

either bay.

o Single SFF hot-plug drive cage

— Left node

— Right node

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 109 110

User Guide 1
Contents 3
Contents 4 4
Contents 5 5
Component identification 6
Front panel LEDs and buttons 7
Rear panel components 8
Rear panel LEDs and buttons 9
System board components 9
DIMM slot locations 10
System maintenance switch 11
Drive numbering 12
Component identification 13 13
Operations 15
Remove the drive air baffle 16
Install the drive air baffle 17
Remove the PCI riser cage 18
Install the PCI riser cage 19
Optimum environment 21
Temperature requirements 22
Rack warnings 23
Installing the chassis 24
Installing options 24
Installing the components 25
Powering up the chassis 26
Configuring the chassis 26
Registering the server 27
Introduction 28
Processor option 28
11. Install the heatsink: 31
Memory options 32
DIMM identification 34
Memory protection modes 34
Installing a DIMM 37
Drive guidelines 38
— Left node 42
— Right node 42
Controller options 52
6. Do one of the following: 54
2X LFF Smart Array option 56
4X SFF Smart Array option 59
Connecting the SUV cable 62
Cabling 69
Personality board cabling 70
System board power cabling 71
• Left node 72
• Right node 72
Mini-SAS cabling 75
Cabling 76 76
FBWC capacitor pack cabling 77
Server mode 78
HP product QuickSpecs 78
HP iLO Management Engine 78
Active Health System 79
Intelligent Provisioning 80
Erase Utility 81
HP Service Pack for ProLiant 82
HP ROM-Based Setup Utility 83
Boot options 84
Configuring AMP modes 84
Utilities and features 85
ROMPaq utility 86
Keeping the system current 87
Software and firmware 88
Version control 88
ProLiant servers 88
Troubleshooting 90
Regulatory information 92
Electrostatic discharge 93
Specifications 94
Support and other resources 95
Customer Self Repair 97
Reparo feito pelo cliente 99
Acronyms and abbreviations 103
Documentation feedback 107
Index 108 108
Index 109 109
Index 110 110

Comentarios a estos manuales

Sin comentarios

Hp ProLiant SL230s Gen8 Server Manual de usuario Pagina 42

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Hp ProLiant SL230s Gen8 Server