
Hardware options installation 60
8.
Cut the plastic cable ties securing the cable assembly to the drive cage.
9. Install the cable assembly included in this kit to the drive cage.
NOTE: Install connectors with cables oriented upward.
10. Use the plastic cable ties from the option kit to secure the cable assembly to the side of the drive cage.
11. Connect the drive cage power cable and temperature sensor cable to the personality board.
12. Route and connect the Mini-SAS cable to the Smart Array controller card.
For detailed cable routing, see Mini-SAS cabling (on page 75).
13. Install any drives or foam blanks previously removed.
14. Install the drive air baffle (on page 17).
15. Install the server into the chassis ("Installing the server into the chassis" on page 25).
16. Power up the server (on page 15).
Installing an expansion board
1. Power down the server (on page 15).
2. Remove the server from the chassis (on page 15).
3. Remove the expansion slot cover from the PCI riser cage.
4. Remove the PCI riser cage (on page 18).
Comentarios a estos manuales