Hp 9000 V2600 SCA Manual de usuario descargar pdf (Pagina 103)

Chapter 5 81

Configuration utilities

ts_config

Configure the scub_ip address

Step 1. Select the desired node from the list of available nodes.

Step 2. In the ts_config display panel, select “Actions” and then “Configure

‘scub_ip’ address,” as shown in Figure 35.

Figure 35 ts_config “Configure ‘scub_ip’ address” selection

ts_config checks the scub_ip address stored in NVRAM on the SCUB

in the node. This would initially be the default address set at the factory.

If the scub_ip address is correct, the panel shown in Figure 36 is

displayed and no action is required. If the node is not detected and

scanned by ccmd, ts_config may ask you to try again later. The ccmd

detection scan process should take less than a minute.

Figure 36 ts_config “SCUB OK” panel

Step 3. If prompted by ts_config (as indicated by the panel in Figure 37), click

“Yes” to correctly set the scub_ip address.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 205 206

Sin comentarios

Hp 9000 V2600 SCA Manual de usuario Pagina 103