Hp DS20L Manual de usuario descargar pdf (Pagina 118)

A-30 AlphaServer DS20L User’s Guide

A.9 Set Commands

This section lists some of the more common set commands and how to use them.

A.9.1 Set Password

The set password command sets the console password for the first time or

changes an existing password. It is necessary to set the password only if

the system is going to operate in secure mode.

Syntax: set password

The password length must be between 15 and 30 alphanumeric characters.

If a password has not been set and the set password command is issued, the

console prompts for a password and verification.

If a password has been set and the set password command is issued, the console

prompts for the new password and verification, then prompts for the old password.

The password is unchanged if the validation password entered does not match the

existing password in the NVRAM.

Example A– 14 Set Password Command

>>> set password

Please enter the password: # Password is not echoed.

Please enter the password again: # Validation is not echoed.

>>>

>>> set password # Changing a password.

Please enter the password:

Please enter the password again:

Now enter the old password:

>>>

>>> set password # Password entered is

Please enter the password: # too short.

Password length must be between 15 and 30 characters

>>>

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 151 152

Sin comentarios

Hp DS20L Manual de usuario Pagina 118