Hp E 800 Manual de usuario

HP Part Number D9394-90000Printed June 2000HP NetServer E 800Installation Guide

Setting Up the HP NetServer E 8006Step 4: Installing Mass Storage Devices• The NetServer is internally limited to 7 mass storage shelves.The flexible

Setting Up the HP NetServer E 80073. Connect the cables (data & power).4. Replace the drive cage.Slots for TabsCaptive Screws (3)First insert scre

Setting Up the HP NetServer E 80085. If necessary, install the internal accessory SCSI cable into SCSI channel Band connect to the SCSI drives or opti

Setting Up the HP NetServer E 80096. If necessary, install the external/internal SCSI cable into SCSI channel Band connect to the knock-out in the rea

Setting Up the HP NetServer E 80010Step 5: Installing Adapter Boards• The NetServer E 800 has two PCI (Primary and Secondary) busses andboth are pear-

Setting Up the HP NetServer E 80011Full-LengthPCI Slot 5PCI Slot 1PCI Slot 6PCI Slot 2PCI Slot 764-bit32-bit32-bit32-bit64-bitSystem Board (Top View)W

Setting Up the HP NetServer E 80012Slot CoverChassisCross-SectionView

Setting Up the HP NetServer E 80013

Setting Up the HP NetServer E 80014Step 6: Installing a Second Processor• Both processors must have the same clock speed and cache size.• Use only pro

Setting Up the HP NetServer E 800151. Open the ZIF (Zero Insertion Force) lever on the processor socket.The ZIF lever must open completely to a full 9

iiNoticeThe information contained in this document is subject to change without notice.Hewlett-Packard makes no warranty of any kind with regard to th

Setting Up the HP NetServer E 800163. Insert the processor into socket, matching pin-1 to marker.Pin-1Marker4. Close the ZIF lever with a click.The ZI

Setting Up the HP NetServer E 800175. Place the Heatsink-Fan on top of processor and follow the steps A-C in thefigure below.Hook Latch(hidden)Process

Setting Up the HP NetServer E 800186. Connect the fan connector to the respective connector on the systemboard.Processor 1 (CPU 1)Processor 2(CPU 2)CP

Setting Up the HP NetServer E 80019Step 7: Configuring the HP NetServer1. Power on the HP NetServer and the monitor:◊ Insert the HP NetServer Navigato

Setting Up the HP NetServer E 80020SCSI controller board from a third-party).You will need to use the NOS vendor’s installation process. Be sure tofir

iiiContentsSetting Up the HP NetServer E 800... 1Introduction ...

1Setting Up the HP NetServer E 800IntroductionThis installation guide is a quick reference for HP NetServer E 800 installation.Skip any steps that do

Setting Up the HP NetServer E 8002Step 1: Attaching all the CablesIf you are not installing any accessories, attach all available cables to therespect

Setting Up the HP NetServer E 8003Step 2: Opening the HP NetServerTools Required:• ¼ inch flat-blade screwdriver• Torx T-15 driverWARNING Before remo

Setting Up the HP NetServer E 8004Front of ChassisBottom of ChassisCoverCoverLatch OpeningAir DuctLatch

Setting Up the HP NetServer E 8005Step 3: Installing Memory• Use only HP DIMMs, which are 3.3V, 168-pin, PC133 (133 MHz),buffered SDRAM DIMMs in 128 M