Hp Media Center m270 Desktop PC Manual de usuario descargar pdf (Pagina 63)

Upgrading

CS SL MA

SLAVE

MASTER

Installing a second hard drive

If your PC model does not have a 6-In-1 memory card

reader, the bottom slot of the drive cage is empty and

can accommodate an additional 3.5-inch hard drive.

1 Remove the drive cage. (See page 52.)

2 Make sure the jumper on the new hard drive is in the

CS (Cable Select) position. Slide the new drive into

the empty slot in the drive cage until the screw holes

align.

3 Install the two screws.

4 Replace the drive cage. (See page 53.)

5 Attach the power cable to the back of the drive.

6 Attach the connector marked

Master

on the IDE

ribbon cable to the back of the preinstalled hard

drive. After the preinstalled hard drive connection

is attached, twist the remaining part of the cable,

marked

Slave

on that same IDE ribbon cable, and

connect it to the second hard drive.

7 If necessary, connect the IDE cable connector marked

Motherboard

CPU board

to the motherboard.

A jumper is a

small plastic

connector or wire

which electrically

connects two pins

in order to define

a configuration

setting.

Example drive with Cable Select jumper

installed (your drive may vary)

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 81 82

Sin comentarios

Hp Media Center m270 Desktop PC Manual de usuario Pagina 63