Hp Slate 21-s100 All-in-One Manual de usuario descargar pdf (Pagina 10)

2 Setting up the hardware

You can install the all-in-one on a desktop or mount it to a mounting fixture such as a wall mount or

swing arm. Be sure to place the all-in-one in a convenient, well-ventilated location. Connect the

cables after you have installed the all-in-one to a mounting fixture.

To set up the all-in-one, ensure that the power is turned off to the all-in-one and all attached

accessories, and then follow the instructions below for your configuration.

Preparing for desk use

To assemble the all-in-one for desktop use:

1. Set the all-in-one face down on a flat, soft, protected table or desk surface.

2. Pull the stand outward until you hear it click.

3. Lift the all-in-one to an upright position and place on a flat, stable surface.

Preparing for wall mounting

NOTE: This all-in-one is intended to be supported by UL or CSA Listed wall mount bracket.

You can only VESA mount the all-in-one in landscape orientation with the rear ports facing down. Do

not place in portrait orientation.

To attach the all-in-one to a mounting fixture:

1. Set the all-in-one face down on a flat, soft, protected table or desk surface.

4 Chapter 2 Setting up the hardware

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Sin comentarios

Hp Slate 21-s100 All-in-One Manual de usuario Pagina 10