Hp Vectra VE 5/series 2 Manual de usuario descargar pdf (Pagina 76)

If You Cannot Use Any Video Resolution Higher Than 640 X 480

If you cannot select a video resolution higher than 640 X 480, you should clear the contents of

the CMOS memory.

To clear the configuration:

1 Switch off the PC and remove the cover (refer to chapter 3 for instructions).

2 Set the system board switch 1 (CONFG) on the switch block to ON to clear the

configuration from the CMOS memory (refer to "System Board Switches" in chapter 5 for

the switch location).

3 Switch on the PC to erase the CMOS memory.

4 Check that error codes 0240 and 0130 are displayed by the Error Message Utility, and wait

until the PC has started.

5 Switch off the PC.

6 Set the system board switch 1 (CONFG) on the switch block to OFF to re-enable the

configuration.

7 Replace the cover (refer to chapter 3).

8 Switch on the PC and run Setup by pressing [F2] when <Setup=F2> appears. (Error code

0130 will appear when the PC starts.)

9 Press [F3] to save the configuration and exit from Setup.

IF YOUR KEYBOARD OR MOUSE DOES NOT WORK

1 Ensure that the keyboard or mouse is correctly connected.

2 Ensure that the mouse driver supplied with the preloaded software is installed correctly.

(Choose a Logitech™ mouse driver for your operating system.)

3 Clean the mouse ball and rollers as shown in the figure below (use a non-residual contact

cleaner).

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 125 126

Sin comentarios

Hp Vectra VE 5/series 2 Manual de usuario Pagina 76