Hp Z400 Workstation Manual de usuario descargar pdf (Pagina 66)

5. If installing a SAS drive, attach a SAS-to-SATA cable adapter to the connector on the SAS hard

drive as shown in the following figure.

NOTE: SAS Drives require a separate SAS Controller plug-in card.

Figure 9-3 Attaching the cable adapter

6. Push the hard disk drive into the selected bay until it snaps into place (1) as shown in the

following figure.

Figure 9-4 Installing the HDD drive

7. Attach a power cable (2) to the drive, and attach a data cable (3) from the SATA port or SAS

controller to the hard disk drive.

CAUTION: To avoid crushing or pinching the data cable when you replace the access panel,

use a data cable with a right-angle connector when you install a HDD in bay 1 or bay 2.

58 Chapter 9 Installing hard disk drives ENWW

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 75 76

Sin comentarios

Hp Z400 Workstation Manual de usuario Pagina 66