HP LX800 Manual de instalación descargar pdf (Pagina 46)

25. Remove the purger quick connector.

Problems with the ink sensor value

1. There are three different cases that can cause a problem.

●

The pressure sensor value is below a limit, which may vary depending on the volume of the

supply. Probably there is an air bubble inside the cartridge connector tube column. Prepare

the syringe again. Press OK and continue with step 2.

●

The ink volume of the cartridge is too low to register on the pressure sensor. To ensure there

are no air bubbles in the tube, you are recommended to purge again. Press BACK and

continue with step 2. If you think there are no air bubbles, press OK and continue the process

of purging the ISM tubes from where you were.

42 Chapter 7 Purge the ink system ENWW

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 85 86

Sin comentarios

HP LX800 Manual de instalación Pagina 46