HP Saw E4419B Manual de usuario descargar pdf (Pagina 173)

HP4402.book : chapter4.fm 7 Fri Feb 12 15:32:45 1999

Error Messages

HP E4419B User’s Guide 4-7

-214 Trigger deadlock

TRIG:SOUR was set to HOLD or BUS and a READ? or MEASure? was

attempted, expecting TRIG:SOUR to be set to IMMediate.

-220 Parameter error;Frequency list must be in ascending order.

Indicates that the frequencies entered using the

MEMory:TABLe:FREQuency command are not in ascending order.

-221 Settings conﬂict

This command occurs under a variety of conﬂicting conditions. The

following list gives a few examples of where this error may occur:

•If the READ? parameters do not match the current settings.

•If you are in fast mode and attempting to switch on for example,

averaging, duty cycle or limits.

•Trying to clear a sensor calibration table when none is selected.

-221 Settings conﬂict;DTR/DSR not available on RS422

DTR/DSR is only available on the RS232 interface.

-222 Data out of range

A numeric parameter value is outside the valid range for the command.

For example, SENS:FREQ 2KHZ.

-224 Illegal parameter value

A discrete parameter was received which was not a valid choice for the

command. You may have used an invalid parameter choice.

For example, TRIG:SOUR EXT.

-226 Lists not same length

This occurs when SENSe:CORRection:CSET[1]|CSET2:STATe is set

to ON and the frequency and calibration/offset lists do not correspond in

length.

-230 Data corrupt or stale

This occurs when a FETC? is attempted and either a reset has been

received or the power meter state has changed such that the current

measurement is invalidated (for example, a change of frequency setting

or triggering conditions).

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 203 204

Sin comentarios

HP Saw E4419B Manual de usuario Pagina 173