HP Compaq Pro 6300 Series Small Form Factor Guía de usuario descargar pdf (Pagina 42)

6. Install guide screws on the sides of the drive. If you are installing a 2.5-inch drive, you must

install the drive in an adapter bracket.

NOTE: The hard drive uses 6-32 isolation mounting guide screws. Four extra guide screws are

installed on the exterior of the hard drive bays. The HP-supplied isolation mounting guide screws

are silver and blue. Refer to

Installing and Removing Drives on page 25 for an illustration of the

extra 6-32 isolation mounting guide screws location.

If you are replacing a drive, transfer the guides screws from the old drive to the new one.

●

If you are installing a 3.5-inch hard drive, install four isolation mounting guide screws (two

on each side of the drive).

Figure 2-26 Installing Isolation Mounting Guide Screws in a 3.5-inch Drive

●

If you are installing a 2.5-inch hard drive:

◦

Slide the drive into the bay adapter bracket, ensuring the connector on the drive is fully

inserted into the connector on the adapter bracket.

Figure 2-27 Sliding the 2.5-inch Drive in the Adapter Bracket

34 Chapter 2 Microtower (MT) Hardware Upgrades

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 103 104

Sin comentarios

HP Compaq Pro 6300 Series Small Form Factor Guía de usuario Pagina 42