HP AA-RSB6B-TE Manual de usuario descargar pdf (Pagina 47)

Installing the SAN Switch 2/8

47hp StorageWorks SAN Switch 2/8 Installation Guide

Configuring SAN Switch 2/8 Network Addressing

Read the following sections for information on how to configure the SAN Switch

2/8 addressing scheme.

Requirements

The following items are required to set network addressing.

■ An IP address from your Network Administrator

■ SAN Switch 2/8 installed and connected to a power source

■ Serial cable (supplied with the switch) for connecting the switch to the

workstation

■ A local workstation (desktop or notebook computer) with:

— Microsoft

® Windows 98, Windows 2000, Windows Millennium Edition,

or Windows NT 4.0 operating system

— RS-232 serial communication software (for example, ProComm Plus or

HyperTerminal)

■ Ethernet cable for connecting the switch to the workstation or to a network

containing the workstation

■ SFPs and cables, as required to connect the switch to the fabric

Setting Network Addresses via a Serial Connection

Use the following steps to verify or change the SAN Switch 2/8 IP address,

subnetmask, or gateway address.

Note: During first time setup, you must replace the factory IP, subnetmask and gateway

addresses with addresses provided by your Network Administrator.

1. Remove the shipping plug from the SAN Switch 2/8 Serial port.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 103 104

Sin comentarios

HP AA-RSB6B-TE Manual de usuario Pagina 47