HP 10-Base-T Manual de instalación descargar pdf (Pagina 35)

HP 10Base-T Hubs Installation Guide B-1

Cables and ConnectorsCables and Connectors

Cables and Connectors

This appendix lists cables that have been tested and verified for use with the

HP ProCurve 10Base-T Hubs. The following topics are covered:

■ overview

■ twisted pair cable/connector pinouts

■ RS-232 connector and cable pinouts

It also includes minimum pin-out information so, if you wish to use an unlisted

cable, you can verify that the cables used in your installation are correctly

wired. Note that each pin-out does not necessarily match the pin-out for the

corresponding HP cable, but cables manufactured to follow the minimum pin-

out will function correctly.

Straight-Through Twisted-Pair Cable for Hub-to-Computer

Network Connection

To connect PCs or other network devices to the hub, use a “straight-through”

10Base-T cable. The twisted-pair wires must be twisted through the entire

length of the cable. The wiring sequence must conform to AT&T 258A (not

USOC). See the Twisted-Pair Cable Pin Assignments section at the end of this

chapter for a listing of the signals used on each pin.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 53 54

Sin comentarios

HP 10-Base-T Manual de instalación Pagina 35