HP 12M Manual de instalación descargar pdf (Pagina 26)

2-12

Installing the HP 10/100 Hubs

Installation Procedures

Installing the HP 10/100 Hubs

Direct Console Access

To connect a console to the

hub, follow these steps:

1. Connect the PC or

terminal to the hub’s

Console Port using the

console cable included

with the hub. (If your PC

or terminal has a 25-pin

serial connector, first

attach a 9-pin to 25-pin

adapter at one end of the

console cable.)

2. Turn on the terminal or

PC’s power and, if using a

PC, start the PC terminal

program.

3. Press [Enter] two or three times and you will see the hub identification

information and the message “Press any key to continue”. Press a key, and

you will then see the hub console commands.

Telnet Console Access

To access the hub through a telnet session, follow these steps:

1. Make sure the hub is configured with an IP address and that the hub is

reachable from the telnet workstation (for example by using a Ping

command to the hub’s IP address)

2. Start the telnet program and connect to the hub’s IP address.

3. You will see the hub identification information and the message “Press

any key to continue”. Press a key, and you will then see the hub console

commands.

If you want to continue with console management of the hub at this time, refer

to the HP ProCurve 10/100 Hub 12M and Hub 24M Management and

Configuration Guide that came with your hub.

console port

console cable supplied

with the hub

PC running a terminal

emulator program, or

a VT-100 terminal

9934.book Page 12 Thursday, January 14, 1999 12:39 PM

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 65 66

Comentarios a estos manuales

Sin comentarios

HP 12M Manual de instalación Pagina 26

Comentarios a estos manuales

Relacionado con productos y manuales para Redes HP 12M