HP 2103R-CSDI Manual de usuario Pagina 29

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 92
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 28
Quick Installation
2-5
Quick Installation
for Managed Hubs
Follow the general steps outlined in Table 2-2 to install and configure the
Edge Router module in a managed ONline or ONcore hub.
Table 2-2
Quick Installation for Managed Hubs
Step
Procedure
Refer to:
1
Unpack the module.
Unpacking Procedures on page 2-6
2
Verify the jumper plug positions on
the base and expansion engines
Verifying Jumper Plug Positions on
page2-7
3
Insert the module into an open slot in
the hub.
The appropriate installation
instructions for your hub type in this
chapter
4
Configure the carrier for possible
operation in an unmanaged hub.
Configuring DIP Switches on page 2-8
5
Attach a management terminal to the
Edge Router console port.
Configuring the Edge Router Engine
on page 3-9
6
Configure the carrier using network
management commands.
Configuring the Carrier in a Managed
ONline Hub on page 3-4
or
Configuring the Carrier in a Managed
ONcore Hub on page 3-5
7
Configure the engine parameters
using Cisco Systems setup
command.
Cisco Systems Getting Started Guide
8
Attach WAN cables to the 60-pin
universal WAN connectors on the
front panel.
Cable Pinouts on page A-5
Vista de pagina 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 91 92

Comentarios a estos manuales

Sin comentarios