HP 510x Guía de usuario descargar pdf (Pagina 17)

ENWW 17

TCP/IP Configuration

Introduction

To operate properly on a TCP/IP network, the HP Jetdirect print

server must be configured with valid TCP/IP network configuration

parameters, such as an IP address. Depending on your printer and

system, this can be done in the following ways:

Note When shipped from the factory, the HP Jetdirect

print server has no IP address. If the HP Jetdirect

print server is not configured with a valid IP

address within two minutes after power up, a

factory default value of 192.0.0.192 will be

automatically assigned. This address must be

reconfigured with a valid address for use on your

TCP/IP network. For more information on TCP/IP

networks, see appendix

● By downloading the data from a network-based UNIX server

using BOOTP (Bootstrap Protocol) and TFTP (Trivial File

Transfer Protocol) each time the print server is turned on.

Note The BOOTP daemon, bootpd, must be running on a

BOOTP server that is accessible by the print server.

● By using Dynamic Host Configuration Protocol (DHCP). This

protocol is supported in HP-UX, Solaris, Linux, Windows and

Mac OS systems. (Refer to your network operating system

manuals to verify that your operating system supports DHCP.)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 101 102

Sin comentarios

HP 510x Guía de usuario Pagina 17