HP 690n Guía de usuario descargar pdf (Pagina 110)

The SNMP v3 agent is enabled when you create an initial SNMP v3 account on the print server. Once

created, any properly configured SNMP management application can access or disable the account.

CAUTION: Creating SNMP v3 accounts with the HP Embedded Web Server removes existing

accounts. Also, you must implement the account information on the SNMP management application.

It is recommended that you use HP Web Jetadmin to configure SNMP v3 and other security settings on

the print server.

To prevent access or interception during SNMP v3 account creation, disable Telnet and enable secure

embedded Web communication using HTTPS.

Create the initial SNMP account by specifying the HMAC-MD5 authentication and CBC-DES data

privacy encryption keys used by your SNMP v3 management application.

CAUTION: SNMP v1 and v2c agents can coexist with the SNMP v3 agent. However, to fully secure

SNMP access, you should disable SNMP v1 and v2c.

Other

Use this tab to enable or disable various protocols supported by the print server for printing, print

services, and management. The items are described in

Table 4-18 Other protocols on page 100.

Table 4-18 Other protocols

Item Description

Enable Print Protocols Select the print protocols to use: IPX/SPX, AppleTalk, or DLC/LLC. (Disable unused

protocols to prevent access.)

For network environments that use these protocols, see

Introducing the HP Jetdirect print

server on page 1.

Because the HP Embedded Web Server uses TCP/IP, you cannot disable this protocol.

NOTE: On HP Jetdirect 635n print servers, all network protocols except TCP/IP are

disabled by factory default.

Enable Print Services Select the print services to use: port 9100, LPD, IPP, FTP, or Web Services Print.

(Disable unused print services to prevent access.)

100 Chapter 4 HP Embedded Web Server (V.40.xx)

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 205 206

Sin comentarios

HP 690n Guía de usuario Pagina 110