HP B3000 Guía de instalación descargar pdf (Pagina 3)

[Enter your Document Title]

[Document Restriction Notice]

Introduction

This paper will provide a step-by-step process for the installation and configuration of the

b3000 v1. It is assumed that the installation will be preformed on a new unit or a unit

that has just been quick restored. Additional information about any of the topics covered

in the document can be located in the Administration guides for the respective products.

Quick Restore

The NAS b3000 v1 Quick Restore CD should be labeled version 2.12.

1. Place the StorageWorks NAS Executor b3000 Quick Restore CD into the

CDROM drive on the b3000. With the CD in the CDROM tray, reboot or turn

on the server. When prompted press “Q” to begin the Quick Restore.

2. When prompted for the second CD, insert the second CD.

If the b3000 being installed is part of a cluster, save time by placing CD 1 into the

second node after it completes on the first node, and start the Quick Restore process.

The Quick Restore process is automated and it is not necessary to interact with the nodes

during the restore process.

Rapid Launch

The NAS b3000 includes a RapidLaunch CD that can run on any Windows-based PC

using Internet Explorer 5.5 (or greater). The WebUI application is designed to be

graphical and easy-to-use, and to assist you in populating information necessary for

configuration.

NOTE: The RapidLaunch utility must be run on each node in a cluster.

Requirements

The following items are required to run the WebUI configuration application:

• Windows-based PC loaded with Internet Explorer 5.5 (or greater) on the same

network segment as the NAS b3000

• RapidLaunch CD

NOTE: The NAS b3000 is designed to be deployed without a monitor, keyboard, and mouse.

These ports are available and supported by the NAS device if used.

To initialize the NAS b3000 using the WebUI configuration application:

CAUTION: Do not power up the NAS device until steps 1-5 are completed.

1. Connect the Ethernet cables to the respective network ports of the NAS b3000.

2. Verify that the Windows-based PC client is connected to the same subnet as

the NAS b3000.

3. Power on the Windows-based PC and wait until the operating system has

completely loaded.

4. Insert the RapidLaunch CD into the CD-ROM drive.

5. The RapidLaunch CD should automatically run. If the program does not

startup automatically, the program may be run manually. Click Start select Run

on the Windows taskbar, and then type the following: {

CD ROM

drive}:\setup.exe.

Wait for the interface to startup.

6. Go to the NAS device and power it on. It will be several minutes before the

NAS device is accessible on the network.

7. Return to the Windows-based PC. Select StorageWorks NAS from the Show

drop down list to have RapidLaunch list all NAS devices on the network.

8. All the NAS devices found on the network are displayed. The NAS device will

be displayed in the device discovery portion of the screen as an unconfigured

device. It may take several minutes for the NAS device to be found on the

1 2 3 4 5 6 7 8 ... 27 28

Comentarios a estos manuales

Sin comentarios

HP B3000 Guía de instalación Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Redes HP B3000