HP Fiber-Optic Hub Plus Guía de usuario descargar pdf (Pagina 30)

Configuration Commands

Several of the console commands allow you to customize the operation of your hub. They are

listed and described here.

Command Name Command Function Factory Preset Value

Backup

Configures one of the hub’s ports for

dedicated use in a backup (redundant) link

to another hub.

No backup link

configured.

IPconfig

Configures the hub to enable

communication with a network

management station using the Internet

Protocol (IP).

IP communications

disabled.

Port

Enables or disables specific hub ports.

All ports enabled.

Thinwatch

Enables or disables Thinwatch. If

Thinwatch is enabled, the Fault LEDs and

ThinLAN port LED will flash if the

ThinLAN port becomes segmented.

Thinwatch disabled.

Note Other console commands allow you to monitor the hub’s activity and to

diagnose hub and network problems. See chapter 3, “Operation”, for console

command details.

You can also receive information about a command at the console prompt by

entering HE (the Help command) followed by the first two characters of the

command, for example HE PO for help on the Port command.

2-14 Installation

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 83 84

Sin comentarios

HP Fiber-Optic Hub Plus Guía de usuario Pagina 30