HP Jetdirect 175x Manual de usuario descargar pdf (Pagina 24)

TCP/IP Configuration
for HP Jetdirect 175x external print server/Internet connector for USB
and HP Jetdirect 310x external print server/Internet connector for
USB
Summary of TCP/IP Configuration●   
Overview of the TCP/IP Protocol●   
Using BOOTP and TFTP●   
Using DHCP●   
Using RARP●   
Using the arp and ping commands●   
Using Telnet●   
Using the embedded web server●   
Using a syslog server●   
Moving the networked printer to another network●   
Ports for IP access to the HP Jetdirect print server●   
Introduction
To operate properly on a TCP/IP network, the HP Jetdirect print
server must be configured with valid TCP/IP network configuration
parameters, such as an IP address. Depending on your printer and
system, this can be done in the following ways:
Note:  When shipped from the factory, the HP Jetdirect
print server has no IP address. If the HP Jetdirect print
server is not configured with a valid IP address within
two minutes after power up, a factory default value of
192.0.0.192 will be automatically assigned. This address
must be reconfigured with a valid address for use on your
TCP/IP network. For more information on TCP/IP
networks, see TCP/IP overview.
By using your printer installation software or the HP Jetdirect
print server installation software on supported systems. For
more information see the software solutions summary.
●   
By downloading the data from a network-based server using
BOOTP (Bootstrap Protocol) and TFTP (Trivial File Transfer
Protocol) each time the printer is turned on. For more
●   

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 201 202

Comentarios a estos manuales

Sin comentarios

HP Jetdirect 175x Manual de usuario Pagina 24

Comentarios a estos manuales

Relacionado con productos y manuales para Redes HP Jetdirect 175x