HP A2969A Manual de usuario descargar pdf (Pagina 19)

If Necessary, Remove the Termination Resistors

If the SCSI Adapter is installed in the middle of a SCSI bus, that is, not at the end as

shown in figure 1 on page 12, the termination resistors on the SCSI Adapter should be

removed. (This would only occur in an HA solution with greater than two CPUs, or if a

V cable is used.)

See figure 3 for the locations of the termination resistors (remember,

the component locations on the two adapters are identical except for the front

faceplate).

Terminatiin resistors

(Part number 1810-1418)

1234

-1

RRAR

II klldMLl

l-l

OPEN

OPEN r

Figure 3. Termination resistor locations

Installation Procedures

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 54 55

Sin comentarios

HP A2969A Manual de usuario Pagina 19