HP Converged Network Adapters (CNA) Manual de instalación

HP Installation Guide, AT118A HP IntegrityNC552SFP 2P 10GbE AdapterAbstractThis document is for the person who installs, administers, and troubleshoot

4. Run swinstall to install the software. Enter the following command:/usr/sbin/swinstallThe Software Selection window and the Specify Source window o

3. Observe whether the ioscan output reports the following:lan 0/3/0/0/0/0 UNCLAIMED UNKNOWNIf reported, HP-UX detected the adapter but the iocxgbe dr

4 SpecificationsCable specificationsTable 2 Cable specificationsMaximum cablelength (meters)MinimummodalCable gradeCore size(microns µm)Wavelength(nm)

Table 4 Compliance (continued)StandardComplianceIPv4/IPv6 TCP, UDP checksum OffloadIPv4/IPv6 TCP, Large Send OffloadIPv4/IPv6 TCP, Large Receive Offlo

5 Regulatory compliance noticesRegulatory compliance identification numbersFor the purpose of regulatory compliance certifications and identification,

Figure 2 Class 1 laser product labelThis optional label indicates that the product is classified as a CLASS 1 LASER PRODUCT. Thislabel may appear on t

BSMI noticeFigure 3 BSMI noticeJapanese noticeFigure 4 Japanese noticeKorean noticesFigure 5 Korean notices16 Regulatory compliance notices

6 Electrostatic DischargeElectrostatic DischargeTo prevent damage to the system, be aware of the precautions you need to follow when settingup the sys

7 HP Contact informationHP contact informationFor the name of the nearest HP authorized reseller:• See the following Contact HP worldwide (in English)

8 Acronyms and abbreviationsAcronyms and abbreviations10GbE10 Gigabit EthernetCSACanadian Standards AssociationIEEEInstitute of Electrical and Electro

© Copyright 2011, 2012 Hewlett-Packard Development Company, L.P.The information contained herein is subject to change without notice. The only warrant

IndexSymbols10GbE, 19AAdapter LEDs, 4adapters, 4Bbracket, 6bracket, low profile, 6, 7BSMI, regulatory compliance notice, 16Ccable specifications, 12ce

Contents1 Introduction...4Overview...

1 IntroductionOverviewThe HP Integrity NC552SFP 2P 10GbE adapter is a dual port 10GbE adapter for the HP Integrityrx2800 i2 and Superdome2 systems. Th

Network managementManagement supportThe AT118A adapter ships with agents that can be managed from HP Systems Insight Manageror other management applic

2 Installing an adapterIMPORTANT: See the following chapter before installing the AT118A adapter: “Installing theHP-UX operating system components” (p

4. Insert the card into the highest-performance PCIe slot available.5. Attach all the cables to the adapter.6. Do not power on the system until the fo

3 Installing the HP-UX operating system componentsHP-UX operating systemThe HP Integrity NC552SFP 2P 10GbE adapter is supported through the HP-UX 11i

Important Ethernet patches and updatesReview the 10GigEthr-03 (iocxgbe) Ethernet Driver for HP-UX Release Notes located at:http://www.hp.com/go/hpux-1