HP NetServer LH 3000 Guía de instalación Pagina 25

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 48
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 24
Chapter 2 Installation
21
Before you install the hot-swap disk drive modules, decide where to place them in
the secondary mass storage cage. Figure 2-11 shows the drive blockers, which
prevent installation of drive modules into unsupported positions.
Drive Blockers
prevent installation
of drive modules into
unsupported positions
Figure 2-11. Drive Blockers in Hot-Swap Mass Storage Cage
NOTE SCSI addresses (IDs) in the secondary hot-swap mass storage
cage are different from and independent of SCSI addresses in
the primary cage. SCSI addresses for devices in both cages for
single-bus and dual-bus configurations are shown in your
HP NetServer installation guide and the HP NetServer Duplex
Kit Installation Guide.
Vista de pagina 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 47 48

Comentarios a estos manuales

Sin comentarios