HP NetServer LXr 8500 Guía de usuario descargar pdf (Pagina 20)

Chapter 1 Server Administration Using HP TopTools

The right Power LED on the rear panel LED display should be green and

the left Attention LED should be off (gray) at this point.

8. If possible, verify the PCI board's operation, before continuing.

9. If you are assured of the PCI board's operation, including its driver,

continue with the next step.

10. If all desired PCI Hot Plug boards have been installed, replace the PCI

access panel.

Refer to the section "Removing the PCI Access Panel" in your Installation

Guide.

NOTE The PCI access panel uses the only short T-15 Torx

screws on

the HP NetServer, to prevent the top cover from catching on

the center support, when it is removed with the PCI access

panel in place.

CAUTION To prevent damage to cables, or a disruption in service due to

a disconnection of cables, use caution when sliding the chassis

into the rack, if not using the Cable Management Arm.

11. If chassis work is complete, slide the HP NetServer chassis back into the

rack (refer to your Installation Guide).

12. Return the HP NetServer to normal operation (refer to your Installation

Guide).

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 46 47

Sin comentarios

HP NetServer LXr 8500 Guía de usuario Pagina 20