HP Visualize b2000 - Workstation Especificaciones descargar pdf (Pagina 123)

Chapter 4 123

Changing Your Workstation’s Hardware Conﬁguration

Hard Disk Drives

Removing a Hard Disk Drive

This procedure explains how to remove your hard disk drive. Note that

there are no cables to disconnect when removing a hard disk drive. To

remove a hard disk drive, your workstation must be turned off.

NOTE If you are removing a hard disk drive that has a mounted ﬁle system on

it, you will need to unmount it. This should be done before you remove

the hard disk drive.

To unmount a ﬁle system on a hard disk drive use the procedure

provided in the section “Removing a Hard Disk Drive as a File System

Using SAM” found in this chapter.

1. Open the side panel of your workstation using the instructions found

in the section “Opening the Side Panel.” As you face the workstation

system board, the hard disk drives are on the right side. The lower

slot (ID5) on the right is the one discussed in this section. See Figure

4-42.

Figure 4-42 The Hard Drive Slots

Hard Disk Drive

SCSI ID 5

SCSI ID 6

SCSI slots

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 228 229

Sin comentarios

HP Visualize b2000 - Workstation Especificaciones Pagina 123