HP Visualize b2000 - Workstation Especificaciones descargar pdf (Pagina 86)

86 Chapter4

Changing Your Workstation’s Hardware Conﬁguration

I/O Cards

appropriately positioned. See Figure 4-8. If the card is full length, the

non-bulkhead end of the card should be placed in the I/O card guide.

Press ﬁrmly and evenly on the I/O card until it is in the connector.

Secure the I/O card to the bulkhead with the T-15 Torx screw.

6. Replace the I/O card retainer by placing the bottom retainer hook in

the slot on the air divider and the clips on the PULL tabs into their

slots on the chassis wall. See Figure 4-7.

7. Close the left side panel of the workstation by following the procedure

in the section “Closing the Left Side Panel” in this chapter.

NOTE If you connect a monitor to a graphics card, you will need to change the

console path as described in “Displaying and Setting Paths” on page 161.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 228 229

Sin comentarios

HP Visualize b2000 - Workstation Especificaciones Pagina 86