HP Visualize c240 - Workstation Manual de servicio descargar pdf (Pagina 187)

171

SCSI Connections

Assigning SCSI Device IDs

1 Write in the type of each device currently connected to your system under the

heading “Ultra, Wide SE SCSI Device Drives” and each drive’s SCSI device ID

under the heading “Device ID.”

2 Add your new drive to the table.

3 Check to see what SCSI device IDs are not used. You may use ID numbers 0

through 6 and 8 through 15 if they are not already in use. If the default ID on your

drive does not conflict with any existing drive IDs, use that ID. If your default

address conflicts with an existing drive ID, assign a new ultra, wide SE SCSI de-

vice ID to your drive. Refer to the drive’s installation documentation for informa-

tion on changing the device ID.

CAUTION: Do not use SCSI device ID 7 for any device.

Table 29 Ultra, Wide SE SCSI Device Drives and Device ID

Ultra, Wide SE SCSI Device Drives

Device ID (Address) Number

(ID 7 not available)

1st Internal Device ______________________________ __________

2nd Internal Device ______________________________ __________

1st External Device ______________________________ __________

2nd External Device ______________________________ __________

NOTICE: You can have no more than 4 SCSI devices connected to a ultra, wide SE bus.

1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 239 240

Sin comentarios

HP Visualize c240 - Workstation Manual de servicio Pagina 187