HP Visualize c3000 - Workstation Manual de instrucciones Pagina 126
- Pagina / 204
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
126 Chapter 4
Field Replaceable Units
FRU Removal and Replacement
Replacing the I/O Fan
Perform the following steps to replace the I/O fan:
1. Install the I/O fan into the fan/speaker mounting bracket by pulling out on the left and
right fan mounting clips, inserting the fan, and then releasing the fan mounting clips so
that they hold the fan in place. See Figure 4-52.
2. Align the fan/speaker mounting bracket in the chassis, holding the fan and speaker
cable to the card guide edge of the mounting bracket. Then rotate the fan/speaker
mounting bracket into place while holding up on the retainer tab.
3. Connect the I/O fan and speaker cables to the system board.
4. Place the air divider within the chassis and screw in the two T-15 Torx screws that hold
the air divider in place. See Figure 4-51.
5. Replace all I/O cards and the PCI retainer clip as explained in the section “Replacing or
Installing I/O Cards” on page 112.
6. Close the left side panel of the workstation as shown in the section “Closing the Left
Side Panel.”
Removing the System Fan
Perform the following steps to remove the system fan:
1. Open the left side panel of the workstation as shown in the section “Opening the Left
Side Panel.”
2. Remove the four plastic pop rivets at the corners of the system fan to release the fan
from the rear panel of the workstation chassis.
3. Disconnect the system fan’s power cable from the system board and remove the fan.
Replacing the System Fan
Perform the following steps to replace the system fan:
1. Align the flow arrow on the system fan so that it is pointing toward the rear panel of the
workstation chassis.
2. Position the fan flush with the rear panel of the workstation and insert the four plastic
pop rivets to secure the fan to the rear panel.
3. Connect the system fan’s power cable to the system board.
4. Close the left side panel of the workstation as shown in the section “Closing the Left
Side Panel.”
- Service Handbook 1
- Restricted Rights Legend 3
- Printing History 4
- Contents 10
- Product Information 15
- Product Description 16
- ISUALIZE 17
- Front Panel Components 18
- Power Switch 19
- Internal Storage Devices 19
- Rear Panel Components 22
- I/O Slots 23
- Monitor Connector 23
- Serial Connectors 23
- USB Connectors 24
- LAN Connector 24
- Parallel Connector 24
- Audio Connectors 25
- TOC Button 25
- Security Loop 26
- Monitors 27
- Keyboard and Mouse 28
- Operating System Overview 29
- Memory Failures 30
- Configuration 31
- Workstation Configurations 32
- Chapter 2 33 33
- 34 Chapter 2 34
- Chapter 2 35 35
- 36 Chapter 2 36
- CD Drive Configuration 37
- Monitor-Type Selection 40
- Troubleshooting 41
- Chapter 3 43 43
- 44 Chapter 3 44
- Chapter 3 45 45
- 46 Chapter 3 46
- Chapter 3 47 47
- Fan Faults and Warnings 48
- Dealing with a Boot Failure 50
- Boot Command Notations 52
- Supported Boot Paths 52
- Selftest Failures 53
- Chassis Codes 54
- Running ODE-Based Diagnostics 79
- 80 Chapter 3 80
- Tools Required 83
- Exploded View Diagram 83
- Front Panel 87
- Left Side Panel 88
- Chapter 4 89 89
- Power Switch/LCD Assembly 90
- Removable Media Devices 91
- Figure 4-21 102
- Hard Disk Drives 104
- Chapter 4 109 109
- Field Replaceable Units 109
- FRU Removal and Replacement 109
- T-15 Torx Thumbscrew 109
- I/O Cards 110
- Chapter 4 111 111
- I/O Slot 1 111
- I/O Slot 4 111
- Memory DIMMs 114
- Chapter 4 115 115
- Ejector Tab 115
- Load 1st 116
- Load 4th 116
- Load 2nd 116
- Load 3rd 116
- 118 Chapter 4 118
- Power Supply 119
- 120 Chapter 4 120
- Voltage Regulator Modules 121
- 126 Chapter 4 126
- Mounting 128
- System Board Tray Assembly 129
- 130 Chapter 4 130
- Two T-15 130
- Torx Screws 130
- Chapter 4 131 131
- 132 Chapter 4 132
- Block Diagram 133
- 134 Chapter 5 134
- Boot Console Handler 135
- Chapter Overview 136
- Boot Console Handler Features 137
- 138 Chapter 6 138
- Chapter 6 139 139
- 140 Chapter 6 140
- Chapter 6 141 141
- 142 Chapter 6 142
- Boot terminated 143
- Booting the Workstation 144
- Chapter 6 145 145
- Searching for Bootable Media 146
- Resetting the Workstation 147
- Displaying and Setting Paths 148
- Chapter 6 149 149
- The Monitor Command 150
- Setting the Monitor Type 151
- Chapter 6 153 153
- 154 Chapter 6 154
- Memory Information Sample 156
- Chapter 6 157 157
- 158 Chapter 6 158
- Chapter 6 161 161
- Displaying System Information 162
- Displaying PIM Information 162
- Stable Storage 162
- ISL Environment 163
- ISL User Commands 164
- Chapter 6 165 165
- 166 Chapter 6 166
- Product Specifications 167
- Environmental Specifications 168
- Electrical Specifications 169
- 170 Appendix A 170
- Appendix Overview 172
- Emissions Regulations 174
- Appendix B 175 175
- Acoustics 176
- Appendix B 177 177
- Warnings 178
- Related Documentation 179
- HP CE Training CD-ROM 180
- Service Manuals 180
- User Manual 180
- Glossary 181
Relacionado con productos y manuales para Barebones Pc / Estación De Trabajo HP Visualize c3000 - Workstation
(29 paginas)
(3 paginas)
(60 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.053 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales