HP Workstation x4000 Guía de instalación

Service HandbookHP x4000 WorkstationManufacturing Part Number: A6068-IE002Edition xxxx© Copyright 2001 Hewlett-Packard Company.

Upgrading MemoryThe memory for the HP x4000 Workstation is located on a MemoryExpander Card, which plugs into the system board.There are two memory ba

Figure 1-1 x4000 Memory Expander Card (MEC)

Figure 1-2 Replacing or Upgrading Memory

Replacing or Upgrading a ProcessorThe x4000 Workstation can have two processors. The processors must beidentical.If you are upgrading your current pro

8. Remove the two heatsink clips by pressing the release lever on theclips. Then lift off the heatsink. There is a thermal interface materialbetween t

4. Open the hard disk drive cage.5. Remove the Chassis Beam Assembly.6. Remove the MEC card.7. Ensure the processor is correctly oriented by matching

15.Reconnect all the power and telecommunications cables.16.Update your operating system (see page 16).Updating Your Operating SystemIf you are adding

2 Accessory Ordering Information

Supported AccessoriesIntel Xeon Processors1.5 GHz A6078A1.7 GHz A6079ASystem RAM256 MB PC800 RDRAM (1 pair 128 MB RIMMs) A6081A512 MB PC800 RDRAM (1 p

North America (ABA)Australia (ABG)Japan (ABJ)Argentina (AC8)United Kingdom (ACC)Switzerland (ACD)South Africa (ACQ)South America (AKH)Israel (AKJ)

Legal NoticesThe information contained in this document is subject to change without notice.Hewlett-Packard makes no warranty of any kind with regard

Mass Storage Device Guide RailsExtra guide rails are attached to the side of the Workstation chassis foradditional mass storage device installations.

3 HP x4000 Parts Information

x4000 Parts and Part Numbers11a1b1d1e1f21c1g2a2b3

Item Description ReplacementPart NumberExchangePart NumberMechanical and Power1 Chassis Assembly— —1a Chassis door (left cover) A6068-62004 —1b 465W p

NS x4000 Miscellaneous Parts Kit:• Tamper detect switch assy• Keylock and keys• Cable routing clip• Rails, no screw (3.25” and 5.25” devices)• EFI met

NS Keyboards:US English and Chinese (ABA & AB2)Canadian French (ABC)German (ABD)Spanish (ABE)French (ABF)Latin America Spanish (ABM)Swiss (ABP &am

DocumentationDescription Part Number CommentsGetting Started Guide A6068-90000 Paper documentAccessory Installation Guide A6068-90010 Paper documentTe

Software and Training CDsWindows Recovery/Install CD Kits:Contains:aa. You cannot order these CDs separately, you must order the kit.Kit Number Window

Contents1. HP x4000 Service InformationOverview ...6x4000SystemBoard...

Contents

1 HP x4000 Service Information

OverviewThis chapter contains information about:• “x4000 System Board” on page 7• “BIOS Identification” on page 9• “Upgrading Memory” on page 10• “Rep

x4000 System Board

System Board SwitchesThe system board includes a 4-pole DIP switch, which lets you configureBIOS functions. Because the switches are read only at syst

BIOS IdentificationThe system BIOS is identified by the version number XX.YM.mm,where:• XX is a two-letter code indicating the system• Y is a one-lett