HP Workstation x4000 Guía de instalación descargar pdf (Pagina 15)

4. Open the hard disk drive cage.

5. Remove the Chassis Beam Assembly.

6. Remove the MEC card.

7. Ensure the processor is correctly oriented by matching the notches on

the processor to the notches on the ZIF socket. Then carefully lower

the new processor into place. When the processor is fully inserted,

close the ZIF lever.

Be extremely careful when you insert the processor. If you bend one of

the pins, it will not go into the socket.

Figure 1-4 Inserting a Processor

8. Affix the new thermal interface material, provided with the new

processor, to the top of the processor.

9. Attach the heatsink to the processor. Use the retaining clips to attach

the heatsink. For easier installation, partially attach both clips by

hooking one end of the side slot in each clip. Press down on the

remaining ends of both clips until they click into place.

10.Connect the heatsink turbo fan power connector to the system board.

The fan connectors are labeled

and on the system board.

11.Replace the MEC card.

12.Replace the Chassis Beam Assembly.

13.Close and secure the hard disk drive cage.

14.Replace the Workstation’s cover.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Sin comentarios

HP Workstation x4000 Guía de instalación Pagina 15