HP Workstation Z800 Guia de preparacion descargar pdf (Pagina 23)

2 Use network cables to connect each panel to the available ports in the network switch.

3 Additionally, connect the Colour Grading panel to the remote unit of the USB extender kit.

4 Use a network cable to connect an available port on the Netgear network switch to the workstation, as

illustrated.

5 Refer to the application installation and configuration guide for instructions on assigning an IP address

to the Autodesk Control Surface.

Connecting the Slave Renderer to a Lustre Workstation

The Lustre Slave Renderer is a single render node that provides automatic background rendering on a

shot-by-shot basis. It is available for the Lustre Master Station, the Station, and the HD Station.

NOTE In comparison, Autodesk Incinerator provides “in-line” processing by several nodes at once. For more

information, see the Autodesk Incinerator Installation and User Guide.

Connect the Slave Renderer to a switch on your GigE house network. Note that the Slave Renderer can only

be used by one Lustre workstation.

Although the Lustre Slave Renderer uses a standard GigE network connection, it requires the higher-bandwidth

Cat-6 cable, to accommodate the increased data that is transmitted.

To connect the Slave Renderer:

1 Connect one end of the Cat-6 cable to an available GigE port on your house network switch.

2 Connect the other end of the cable to one of the on-board GigE ports of the Slave Renderer machine.

Connecting the Slave Renderer to a Lustre Workstation | 19

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

Sin comentarios

HP Workstation Z800 Guia de preparacion Pagina 23