HP xw4200 Especificaciones rápidas descargar pdf (Pagina 54)

4–20 www.hp.com Getting Started Guide

Troubleshooting

NOTE: For the following LED activity and beeps, the beeps will be

heard through the on–board piezo speaker and not the chassis

speaker. Blinks and beeps will be repeated for 5 cycles, after that, only

the blinks will continue to repeat.

Red Power LED

blinks four times

once every second,

followed by a

two-second pause.

4Power failure

(power supply

is overloaded)

1. Open the hood and

ensure the 4-wire

power supply cable is

seated into the

connector on the

system board.

2. Check if a device is

causing the problem by

removing ALL attached

devices (such as hard,

diskette, or optical

drives, and expansion

cards.) Power on the

system. If the system

enters the POST, then

power off and replace

one device at a time

and repeat this

procedure, until failure

occurs. Replace the

device that is causing

the failure. Continue

adding devices one at

a time to ensure all

devices are functioning

properly.

3. Replace the power

supply.

4. Replace the system

board.

Activity Beeps

Possible

Cause

Recommended

Action

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 60 61 62

Comentarios a estos manuales

Sin comentarios

HP xw4200 Especificaciones rápidas Pagina 54

Comentarios a estos manuales

Relacionado con productos y manuales para Barebones Pc / Estación De Trabajo HP xw4200