HP ap5000 All-in-One Point of Sale System Manual de usuario descargar pdf (Pagina 57)

6. Remove the two screws below the display screen (1) and slide the display off the system (2).

Figure 7-11 Removing the VFD Customer Display

7. Route the serial cable of the new display through the center hole in the hinge area and connect

the cable to the same COM port on the I/O panel that was used for the old display.

NOTE: If you are replacing the VFD customer display with an LCD customer display, connect

the VGA cable of the LCD customer display to the VGA connector on the I/O panel.

8. If you are removing but not replacing the customer display, cover the slot for the display with the

customer display cover provided with the system. Slide the top of the cover in first (1) then press

the bottom of the cover in place (2).

Figure 7-12 Covering the VFD Customer Display Slot

Removing and Replacing the VFD Customer Display 49

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 88 89

Sin comentarios

HP ap5000 All-in-One Point of Sale System Manual de usuario Pagina 57