HP XM600 Manual de usuario descargar pdf (Pagina 3)

Installing and Replacing Hardware Parts in Your PC Workstation

Removing and Replacing the Cover and Front Bezel

Removing the

Cover

For your own safety, it is recommended that you first read the warning

notices on in the Introductory Section.

1 Switch off the display and computer. Disconnect all power cables and

any LAN or telecommunications cables.

2 Unscrew the two thumb screws located at the back of the PC

Workstation.

3 Standing at the back of the PC Workstation, slide the cover towards you

until it clicks into place.

4 Tilt the cover sidewards, then lift off the PC Workstation chassis.

Removing the

Front Bezel

5 If required, remove the front bezel which is divided into two sections:

• The upper bezel (blue) gives access to three 5.25-inch shelves and two

3.5-inch shelves.

• The lower bezel (grey) gives access to the control panel. To access the

lower bezel, you must first remove the upper bezel.

➍



Chapter2.fm Page 3 Wednesday, December 8, 1999 6:13 PM

1 2 3 4 5 6 7 8 ... 40 41

Sin comentarios

HP XM600 Manual de usuario Pagina 3