HP 600N Manual de instalación descargar pdf (Pagina 32)

3-6 Control Panel Configuration

Configuring IPX Source Routing

(Token Ring Cards Only)

On an IPX/SPX network, the HP JetDirect Token Ring print server

must be configured with the type of Token Ring source routing used

on the network. In most cases, you can keep the default setting,

which is AUTO (“Automatic”). However, you can manually set

source routing if required.

Note that the IPX/SPX protocol must be enabled (IPX/SPX=ON*)

before you can configure source routing.

The possible routing selections are:

To configure IPX source routing

1. Take the printer offline by pressing [Go]. The “Ready” LED

should be off.

2. Press

[Menu] repeatedly until EIO # JETDIRECT MENU is displayed

(# identifies the EIO slot number of the card).

Source Routing Description

AUTO (default) The type of source routing required by the network

environment will be automatically sensed.

OFF All packets are sent without source routing. The JetDirect

card will only respond to stations that are on the same

ring.

SINGLE R All packets are sent with source routing. The Single Route

method is used for broadcasts and when the route is

unknown.

ALL RT All packets are sent with source routing. The All Routes

method is used for broadcasts and when the route is

unknown.

S00eiohw.book Page 6 Thursday, February 24, 2000 2:26 PM

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 53 54

Sin comentarios

HP 600N Manual de instalación Pagina 32