HP 10BASE-T Manual de instalación descargar pdf (Pagina 21)

To install the router module:

1. Using a Torx T-10 or flat-blade screwdriver, loosen the two captured

screws holding the cover plate over the hub’s Expansion Slot, then

remove the cover plate. Note that the screws are spring-loaded and

will release outward when unscrewed far enough. Do not unscrew

them completely from the cover plate.

2. Wrap one end of a grounding wrist strap (one is supplied with the

router module) around your wrist. Connect the other end as follows:

• If using the grounding wrist strap supplied with the hub, connect

the other end to the unpainted surface at the left of the hub’s

Expansion Slot.

• If using a grounding wrist strap that has an alligator clip at the

other end, connect the clip to the left screw on the back of the

hub.

Loosen these two screws

Figure 1-3. Cover Plate Screws

Connect grounding

wrist strap here ...

... or here

Figure 1-4. Connecting Grounding Wrist Strap

Installation

3. Install the Router Module.

1-11

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 103 104

Sin comentarios

HP 10BASE-T Manual de instalación Pagina 21