HP 10BASE-T Manual de instalación descargar pdf (Pagina 78)

8. Using your fingers (or a nonmetallic tool), carefully lift up the

battery clip slightly, then slide the battery out of its holder.

Caution Replace the battery only with the same type.

9. Carefully insert the new battery—positive (+) side up—into the

battery holder.

10. Reassemble the the router module with the SNMP module, then rein-

stall them in the hub, as described in steps 6 – 12 on pages 1-13 – 1-15.

WARNING Dispose of the used battery properly. Do not attempt to recharge,

crush, or disassemble it; do not incinerate it or expose it to heat

above 100°C (212°F).

Figure 4-1. Removing Battery

Troubleshooting

Replacing the Battery

4-16

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 103 104

HP AdvanceStack Router 1
210 Module 1
Installation Guide 2
HP AdvanceStack 2
Router 210 Module 2
About This Manual 4
An Overview 5
Contents 8
3. Operation 9
4. Troubleshooting 9
A. Cables and Connectors 9
B. Specifications 9
C. SmartBoot 10
Regulatory Statements 10
Installation 11
Installation Summary 12
003 X.21 (28606-63001) 14
Option Cable 14
001 V.35 (28606-63008) 14
Looking at the SNMP Module 15
Button switch 16
If this LED is present 16
Using HP Stack Manager 17
2. Prepare the Network 18
3. Install the Router Module 20
Loosen these two screws 21
Connect grounding 21
... or here 21
Press here 23
Router module above 24
SNMP module below 24
Extractor handles 24
Tighten two screws 25
Install two hex nut screws 25
4. Connect the WAN Cable 26
Self-test LED 31
Setup Summary 35
Using the Main Menu and NCL 36
NCL prompt 37
Using Quick Configuration 39
2. Set the Date and Time 41
(Optional) 42
4. Verify the Network Links 43
Examine the Event Log 44
The event log line, showing 45
the router boots 45
Test Node Accessibility 51
Operation 52
LEDs and Buttons 53
Table 3-1. Status LEDs 54
Operation 54
LEDs and Buttons 54
Reset and Clear Buttons 55
Resetting and Clearing 56
Clearing the Passwords 57
Clearing the Router Module 58
Initialization Sequence 61
Troubleshooting 63
Basic Troubleshooting Tips 64
Verifying LED Operation 68
Diagnostic Tests 71
Checking the Configuration 72
Testing a Link 73
Replacing the Battery 77
Cables and Connectors 79
HP Cables 81
Cable and Connector Pin-Outs 82
Cables and 85
Connectors 85
Back-to-Back Test Cable 86
Loopback Connector 88
Specifications 89
Power Consumption 90
Environmental 90
Electromagnetic Emissions 90
Certifications 91
Third-Party Products 91
SmartBoot 92
*5963-2632* 104

Comentarios a estos manuales

Sin comentarios

HP 10BASE-T Manual de instalación Pagina 78

Comentarios a estos manuales

Relacionado con productos y manuales para Routers HP 10BASE-T