HP SuperStack Firewall Series Manual de usuario Pagina 143

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 214
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 142
Configuring High Availability 143
Configuring High Availability on the Backup Firewall
Both steps must be completed before the two Firewalls will function as a
High Availability pair.
Configuring High
Availability on the
Primary Firewall
Click the High Availability button on the left side of the Firewall browser
window, and then click the Configure tab at the top of the window. A
window similar to the following displays.
Figure 60
High Availability Menu
The top half of the window displays the primary Firewalls serial number
and network settings. The bottom half of the window is used to
configure High Availability:
1 To e na b le High Availability,checktheEnable High Availability box.
2 Enter the Serial Number, LAN IP Address and WAN IP Address of the
backup Firewall.
The Serial Number and LAN IP Address are required settings for the
backup Firewall. The WAN IP Address field may be left blank if remote
management is not required for the backup Firewall.
3 Check the Preempt mode checkbox to cause the primary Firewall to take
over from the backup Firewall whenever the primary is available (for
example, after recovering from a failure and restarting).
DUA1611-0AAA02.book Page 143 Thursday, August 2, 2001 4:01 PM
Vista de pagina 142
1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 213 214

Comentarios a estos manuales

Sin comentarios