HP 100BaseT Manual de instalación descargar pdf (Pagina 7)

3. Check the LEDs on the hub’s front panel.

When the hub is powered on, it performs a 10 second self-

diagnostic test. During the test, each LED is lit momentarily.

When the self-test completes successfully, the following

events occur:

Before self-test completes, all of the LEDs light momentarily.

The following table describes the meaning of the LEDs:

LED Meaning

Activity% Reflects the amount of traffic on the

network as a percentage.

Collision% Identifies the percentage of collisions

which shows network saturation.

Partition Displays whether a port experienced

excessive collisions or the BNC port is not

properly terminated.

Link/Activity Displays the amount of network traffic for

this port.

Note that the bottom of the hub also provides information

about the meaning of the LEDs for this hub.

4. Before mounting the hub, unplug it. After the hub has passed

its self-test, you are ready to mount the hub.

Power LED stays on

The BNC Partition LED will remain lit unless a

properly terminated thin coax segment is

attached. This LED does not affect the operation

of the other ports.

A Link/Activity LED stays on if a signal has been detected

through a cable connected to the corresponding port. A

Link/Activity LED turns off a signal is not detected.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Sin comentarios

HP 100BaseT Manual de instalación Pagina 7