
Removal and replacement procedures 44
5.
Release the retainer clip.
6. Press the slot release lever and swing the slot release lever upward.
7. Remove the expansion board.
CAUTION: Make a note of board locations. Be sure to install replacements in the same slots.
To replace the component, reverse the removal procedure.
Slot release lever
To remove the component:
1. Power down the server (on page 31).
2. Extend the server from the rack, if applicable ("Extend the server from the rack" on page 30).
3. Remove the access panel ("Access panel" on page 33).
Comentarios a estos manuales