HP ElitePad 1000 G2 Healthcare Tablet Manual de usuario descargar pdf (Pagina 21)

HP ThinState

IMPORTANT: HP ThinUpdate has imaging functionality intended to replace HP ThinState (see HP ThinUpdate

on page 15).

HP ThinState can be used to capture an HP thin client image that can then be deployed to another HP thin

client of identical model and hardware.

CAUTION: HP supports performing only up to three HP ThinState capture and deployment cycles based on

the same image. Performing more than three cycles might corrupt the image.

To perform an HP ThinState capture:

1. On the thin client you are capturing the image from, make sure the rst boot device in the BIOS is set to

USB.

2. Disable UWF.

3. Insert a USB ash drive that is greater in size than the onboard ash drive.

4. In the Control Panel, select HP ThinState Capture.

5. Follow the on-screen instructions.

NOTE: Windows detects the formatted USB ash drive as a 1 GB drive that uses the FAT32 le system. This

is because the USB ash drive is formatted with two partitions. The FAT32 partition contains the boot

instructions. A second partition, which uses the NTFS le system, contains the image but is not detected by

Windows when you are viewing the drive contents.

Use the USB ash drive to deploy the captured image to another HP thin client of the exact same model and

hardware.

NOTE: With HP ThinState Capture, you might be able to capture the image from a larger ash and deploy it

to a smaller ash, depending on the size of the captured image.

To perform an HP ThinState deployment:

1. On the thin client you are deploying the image to, make sure the rst boot device in the BIOS is set to

USB.

2. Insert the USB ash drive that contains the captured image, and then restart the computer.

3. Follow the on-screen instructions.

After you remove the USB ash drive and cycle power to the system, the image will unbundle. Do not interrupt

or cycle power to the unit during this process.

HP ThinUpdate

HP ThinUpdate is an imaging tool that allows you to capture an HP thin client image or download one from

HP. The image can be saved to local storage or to a USB ash drive, which can be used to deploy the image.

To open HP ThinUpdate:

▲

In the Control Panel, select HP ThinUpdate.

For more information, see the administrator guide for HP ThinUpdate.

HP ThinState 15

1 2 ... 16 17 18 19 20 21 22 23

Sin comentarios

HP ElitePad 1000 G2 Healthcare Tablet Manual de usuario Pagina 21